Description
The Dent Fix GLUEMAX Tension Puller Set pairs the 18" and 36" GLUEMAX lateral tension bars in one kit for glue pull repair on steel and aluminum panels. Creases fight back because tension is locked in the surrounding metal. Glue a Tension Tab at each end of the damage, seat the feet, and turn the knob to spread the panel. With the tension relieved, the crease pulls evenly and the metal goes where you want it.
Use the 36" bar on long creases, quarter panels and large collision damage in a single setup, and the 18" bar on shorter creases, body lines and tight areas where a full-length bar won't fit. Each bar has a fully enclosed drive, protected from glue, dust and shop debris. Set tension by feel with the hand knob, or run the legs in and out with a power drill for faster setup. Straight and Offset Legs swap by hand in seconds with quick-change pins.
Pair the set with the GLUEMAX Mini Dent Lifter (DF-GM600SP) or the GLUEMAX Spring-Loaded Mini Slide Hammer (DF-GMSH) to pull lows while tension is held. Dent Fix part number DF-GMTPS.
Key Features & Benefits
- 36" bar for long creases, 18" bar for tight areas
- Relieves lateral tension so creases pull evenly instead of fighting back
- Hand knob control for small, precise tension steps by feel
- Power drill adjustment for faster leg setup, then fine tune by hand
- Enclosed drive mechanism protected from glue, dust and shop debris
- Two leg sets per bar: Straight Legs for focused tension, Offset Legs for a wider spread
- Quick-change pins swap legs by hand in seconds, no tools needed
- Square and Long Tension Tabs with a raised spine for a secure hold under tension
- Works with the GLUEMAX Mini Dent Lifter, Mini Slide Hammer and Dent Fix Blending Hammer 4 PC Set (DF-BHSET)
- Glue pull repair with lateral tension preserves the OEM finish
Package Includes
- (1) GLUEMAX Tension Bar, 36", with Tension Knob
- (1) GLUEMAX Tension Bar, 18", with Tension Knob
- (4) Straight Legs
- (4) Offset Legs
- (8) Square Tension Tabs
- (8) Long Tension Tabs
Ideal Applications
- Long creases and body line damage (36")
- Shorter creases and tight panel areas (18")
- Large collision damage on doors, quarter panels and bed sides
- Steel and aluminum panels
- Relieving lateral tension before and during glue pulls
- Repairs where preserving the OEM finish matters
- Collision repair shops and PDR technicians
Specifications
- Brand: Dent Fix
- Part Number: DF-GMTPS
- Bar Length: 36" and 18"
- Adjustment: Hand knob or power drill
- Mechanism: Enclosed drive
- Leg Sets: Straight and Offset, quick-change pins
- Square Tension Tab: 2" x 1.9" (5.2 x 4.8 cm)
- Long Tension Tab: 4.1" x 1.9" (10.5 x 4.8 cm)
- Panel Compatibility: Steel and aluminum
- Manual: GLUEMAX Tension Pullers Operating Manual (PDF)